Tarot T810 Flying 3D Hovering With One Motor Dead
The Tarot T810 was equipped with DJI OSD and NAZA-M V2, one of the motors went down during flight,and it did 3D hovering before it went dead. it’s more than 800m in the sky, but it finally goes back to ground safely.
The equipment with it: Tarot t810, hengli 4822 motor, hobbywing platium 30A ESC, maza-m, 4S 5200mah*2. The motor worked an while and then stops,but starts to work again after a few seconds and then stops again, and keep in this situation until it came back. I found that’s because the connector came loose after it went back:( It’s so lucky it didn’t crashed.